-
CPC-II
The CPC is an electrohydraulic pressure-regulating valve control that utilizes a very accurate internal pressure sen... -
VariStroke-I
The VariStroke-I is a linear electro-hydraulic actuator that utilizes a double-acting or single-acting power cylinde... -
PGPL Actuator/Driver
The PGPL Actuator/Driver is an electrohydraulic actuator with a proportional driver interface (purchased separately)... -
Hydraulic Amplifier
Two models of this type amplifier are available. The large 7.25 inch (184 mm) and the smaller 5.25 inch (133 mm) mod... -
TG-13E/-17E Actuator
The TG-13E and 17E proportional electro-hydraulic actuators convert an electrical signal to a corresponding proporti... -
Electrohydraulic Power Servo
The Electrohydraulic Power Servo is a three-stage servo valve used in conjunction with a customer-supplied power cyl... -
Electrohydraulic Power Cylinder
The EHPC is a linear integrating actuator typically used for steam turbine control-valve or valve-rack positioning. ... -
TM-25LP/-200LP Actuator
The TM-25LP and TM-200LP actuators are electric-hydraulic, proportional actuators for positioning steam and fuel-con... -
TG Governor
Simplicity and low cost are distinct advantages of the TG Governors. The governors operate with speed droop for stab... -
UG-25+ Actuator
The Woodward UG-25+ Actuator is a microprocessor-controlled, mechanical-hydraulic amplified, actuator for controllin... -
UG-25+ Governor
The Woodward UG-25+ governor is a microprocessor-controlled, mechanicalhydraulic amplified, governor for controlling... -
EGB-200P/300P
The EGB-200P/-300P is a governor/ actuator providing the electronic governor with 200/300 lb-ft (270/400 Nm) work c... -
EGB-10P/13P/35P
Under electronic control, speed and droop adjustments are made to the electronics. Most electronic controls provide ... -
PGG Governor
The PGG is a mechanical-hydraulic, pressure-compensated governor that combines a permanent-magnet, speed-setting mot... -
PGA-EG Governor
Backup speed control is accomplished by the simultaneous operation of hydro-mechanical (PGA) and electronic (EG) gov... -
PGA Governor
The PGA is a pressure compensated, hydraulic governor that uses an air signal to establish the engine speed setting ... -
UG-MAS Governor
The UG MAS is a pressure compensated, hydraulic governor designed to accept a standard 4–20 mA electrical current si... -
UG-40 Governor
Lever Governor Engine speed on the Lever governor is set with a speed shaft having almost 90° rotation for the full ... -
UG Governor
UG Governors (generally known as the “UG-8”) are available in either a UG Dial or UG Lever configuration. Each model... -
EG-3P/6P/10P
The EG-3P/6P/10P actuators convert an electrical signal to a proportional rotary output shaft position to control th... -
PGG-EG Governor
The PGG-EG governor/actuator combines the proven dependability of the hydromechanical PG governor with the flexibili... -
SG Governor
Available in work ratings of 10.8 and 21.7 inch-pounds, the SG hydraulic speed-droop type governor is designed for u... -
PSG Governor
The PSG governor providers hydraulic powered travel in the increase-fuel direction only. A return spring is used to ...